LeakSMART Water Sensor

The Unofficial SmartThings Blog
Jump to: navigation, search

Brand: LeakSMART

Model: 8840100H

Type: Water Sensor

Protocol: Zigbee

Capabilities: Water Sensor, Temperature Measurement, Battery, Refresh, Configuration, Polling

Device Type Author: Eric Vitale (@ericvitale) https://github.com/ericvitale

Information

Reset / Pair Instructions

  1. Put the ST app into pairing mode.
  2. Press and hold the button for 5-6 seconds (I can't remember if it blinks differently or not once it resets).
  3. Pull 1 battery out, hold down the button.
  4. Push the battery back in and let go of the button immediately (as soon as the battery is in < 500ms), you should hear a short loud beep.
  5. Wait 4-5 seconds and press the button once quickly, don't hold it down.


SmartThings Hub Version This device works with both Version 1 and Version 2 of the SmartThings hub. There is a compatibility mode setting in the device handler that needs to be enabled if you are using version 1 of the hub.

Device Type

https://community.smartthings.com/t/release-leaksmart-water-sensor/53489